Is your Redmi A1 refusing to charge, or only charging when the cable is held just right? A worn charging port is often the culprit, and this OEM charging port board can get your phone plugged in and powering up again.
What You’re Getting
This replacement board comes with the IC chip already fitted, so you get the charging circuitry as one unit. Each board is checked for good condition before it leaves our shelves. The supplier confirms it is built to fit and work as intended, so there is no guessing about whether it will line up with your phone.
Why This Part Works
Swapping out the whole board, rather than only the port, means the charging chip gets replaced along with the connector. That matters when the fault sits deeper than the socket itself. Your phone should charge reliably again, and you won’t have to keep wiggling the cable to make it work.
Installation Notes
Before you open the phone, switch it off and disconnect the battery if your model allows it. Wear an ESD strap or touch a grounded metal surface first, because static can quietly kill fresh electronics. Take care with the flex cables, and never bend them past 90 degrees. If you’re not comfortable with micro-soldering or delicate disassembly, a qualified technician is the safer route.







