Phone won’t charge, or only charges when the cable is wiggled just right? That usually points to a worn charging port, and it’s a fixable problem.
What You’re Getting
This OEM charging port board for the Xiaomi Redmi Note 10 Pro 4G comes with the IC chip already on the board. You get a complete replacement board, not just a loose connector, so the charging circuit is ready to go once it’s fitted.
Each board is checked for good condition before it leaves our warehouse. It’s designed to fit the Redmi Note 10 Pro 4G and to work as a direct swap for the damaged original.
Why This Part Works
The IC chip sits right on the board, so charging control stays with the new part instead of depending on the old, damaged section. That means fewer surprises after the repair.
Swapping the whole board is often quicker than chasing down individual faults, and it gets your phone back to charging reliably.
Installation Notes
Power the phone off and disconnect the battery before you start. Wear an ESD strap so static doesn’t harm the new board. Handle the flex cables gently and never bend them past 90 degrees, or you could tear a trace.
If you’re not comfortable with micro-soldering or opening the device, a qualified technician can fit this board for you. Working slowly and labelling screws as you go helps a lot.







