Get your Redmi Note 10 4G charging reliably again with a replacement port board built to fit the original layout.
What You’re Getting
This OEM charging port board comes with the IC chip already mounted. It’s designed to swap out a worn or faulty port without rebuilding the rest of the phone. Each board is checked for good condition before it leaves our shelves, so you aren’t starting with a dud.
Why This Part Works
A failing charging port often causes slow charging, loose cables, or no charge at all. This board takes over that job with a fresh connector and chip. It’s a direct route back to a phone that powers up the way it should.
Installation Notes
Work on a clean, well-lit bench and power the phone off fully before you start. Wear an ESD strap to protect the chip from static. Keep flex cables under 90 degrees when you lift or fold them, because sharp bends can crack the traces. If you’re not confident with micro-soldering, have a qualified technician fit the board, since installation errors aren’t covered by the part itself.







