Tested replacement built for repair benches. This charging port board is designed for the Xiaomi Redmi Note 9 5G and Redmi Note 9T, model numbers M2007J22G and M2007J22C.
What You’re Getting
You receive a new charging port board that replaces a damaged or unreliable one. Each board is checked for good condition before it leaves our warehouse, so you start with a working part rather than a gamble.
The board carries the charging connector that your phone uses to take power and sync data. When that connector wears out or breaks, the phone may charge slowly, stop charging, or refuse to recognise a cable at all.
Compatibility
This board matches the Redmi Note 9 5G and Redmi Note 9T only. Check that your model number matches M2007J22G or M2007J22C before ordering. Fitting it to a different Redmi or Xiaomi model will not work.
Installation Notes
A qualified technician should fit this part. Work on a clean surface and test the phone before fully reassembling it. Wear an ESD strap to protect the motherboard from static discharge. Keep flex cables under 90 degrees when you lift or move them, because sharp bends can crack the ribbon.
Once installed, plug in a known-good charger and confirm the phone charges and detects the cable before closing the case.







