Is your Redmi K60 Pro’s screen flickering, stuck, or refusing to light up? A faulty display connector on the motherboard is often the culprit, and this replacement part can get your phone back in working order.
What You’re Getting
This listing covers an LCD display FPC connector that sits on the motherboard. Each piece is checked for good condition before it leaves our warehouse. The pack contains 10 pieces, so you can keep spares on hand for repairs or for a workshop.
Why This Part Works
The connector carries the signal between the board and the display, so a clean, properly seated link matters. This part is designed to replace a damaged or unworkable original, and it is supplied as a new unit ready to fit. Once it is in place, touch, image, and backlight should behave normally again.
Installation Notes
Work on a clean, well-lit bench and power the phone off before you start. Wear an ESD strap to protect the board from static discharge. Lift flex cables gently and never bend them past 90 degrees, or you risk tearing the traces. If you are not confident with micro-soldering, a qualified technician is the safer choice, because the supplier notes that damage during fitting is not covered.
