Fingerprint not responding when you need it most? A dead sensor can make your Honor X40i feel locked out of its own life.
What You’re Getting
This is an original fingerprint sensor flex cable in gold, built to replace the part that reads your thumb or finger. Each unit is checked for good condition before it leaves our shelves, so you start with a working piece instead of guesswork.
The flex carries the sensor signal back to the board. Swap it in and the unlock feature should pick up where it left off.
Why This Part Works
Gold matches the colour finish of the X40i, so the repaired phone still looks like it did on day one. The cable is supplied as a complete assembly, which means no hunting for loose clips or extra pieces.
Installation Notes
Work on a clean, well-lit table and power the phone off before you begin. Wear an ESD strap or touch a grounded metal surface first, since static can quietly kill a sensor. Lift connectors gently and never bend the flex cable past 90 degrees, or the traces may crack.
If you’re not comfortable opening the phone, a technician can fit this in minutes. Test the fingerprint setup again before you reassemble the back cover.









